Movement in AT2 is more complicated than in CBT. You will not be
allowed to hit the done button until you have used up all of your
current velocity.  The best thing to do would be to review the
Aerotech rules in Total Warfare before you begin play.

When you move forward on the map, you will see three numbers next to your vessel like this: x[y](z). 
These numbers are:
	x = thrust used thus far (for turns, acceleration, etc.)
	y = velocity remaining that needs to be used
	z = total velocity

You will not be allowed to complete the turn until that middle number
is zero.  You can only spend velocity by moving to new hexes.

A couple of other things to keep in mind: 

   - You must move at least one hex before turning unless your
     velocity is zero.
 
   - large craft are limited in the number of turns they can take in a 
     single hex and the thrust cost for a turn depends on velocity.

   - You can only accelerate and decelerate at the beginning of the
     turn. Once you have made any other movements, hitting the
     acceleration/deceleration buttons will give you an illegal move.

   - the acc next and dec next can be used to set your velocity at the
     start of the next turn, but keep in mind if you do this you will
     not be able to acc/dec at the start of the next turn.

   - It is entirely possible to get in a situation where you will not
     be able to turn your vessel before exiting off of the map.  The
     only way to deal with this is to move to the map edge which will
     make the "flee" button accessible.  Sorry, but you should have
     planned a little further ahead.

   - If your vessel is out of control, shutdown, or pilot is unconscious, then
     just hit the "done" button.  Your vessel will move in a straight
     line by velocity, unless it is randomly moving.  Then it gets
     really fun.

     
******ADVANCED MOVEMENT*******

Advanced movement works very differently from regular movement.  Before attempting to use
it, you should definitely read the section on advanced movement in Aerotech 2 (revised).  

When using advanced (vector) movement, you no longer click where you want to go on the map.  
Based on your active vectors, an arrow will show the hex your vessel will move toward.  To change 
your facing, turn in the appropriate direction and apply thrust (using the buttons). The hex you 
are currently in will show how the active vectors change and the arrow will also change. 
Keep in mind that your facing  in the new hex will be whatever facing you have when you hit "done."   

Currently if you choose a starting velocity in the lobby, the program will assign you an active vector
of that magnitude in the direction you choose to face during deployment.